⎝⎛百乐宫网上游戏⎞⎠

Unified Communications

Provide local, private, public or hybrid solutions

solution

Factory wireless monitoring networking scheme

Due to the large scale of the plant, it is difficult to set up a traditional wired monitoring system.To set up a new monitoring system is completely digital, and using the MOBISYS wireless transmission system, it can provide high-definition video without being affected by the plant. The binding of wiring is convenient and simple to install.
The factory area plans to arrange 22 cameras, and wirelessly transmit the images to the monitoring room, and the images are stored in the monitoring room to monitor the conditions in the factory area in real time.
I. Application characteristics and advantages of wireless monitoring in the factory area:
无线 Real wireless application: The front-end adopts the HD camera + wireless bridge method, which completely avoids the problem of wiring everywhere. You can install the HD camera in any place where it is needed without being restricted by the wiring, which greatly reduces the workload of wiring. And the danger of wiring errors.
广 Wide monitoring area: The advantages of network monitoring are not only to solve the problem of remote wiring, there are no restrictions on cable length and signal attenuation. Because the network is used to transmit signals, the concept of area is completely abandoned, and where the network extends, you can Where to monitor  Scalability: All devices are identified by IP address. At the same time, the MOBISYS 300M wireless bridge device is used, and the device can be simply expanded by the IP address.
灵活 Convenient, flexible, safe, reliable, and easy to upgrade: The design plan fully considers the capacity. When you need to increase the monitoring point, as long as you place a camera and a wireless bridge on the front end, you can quickly access the original monitoring system. At any node in the network, the In the office computer, a set of corresponding remote monitoring software is installed to form a monitoring center.
Second, the overall solution architecture
The entire wireless digital video surveillance system can be divided into three parts: the front-end camera, the link transmission part, and the monitoring center. The use of 5.8G products in the project can first avoid interference from 2.4G household products, and secondly there are more complementary interference channels in the 5.8G channel. It is very suitable for the networking of large-scale systems. And it uses 300M bandwidth equipment to increase network scalability. Firstly, 22 monitoring points are planned as five convergence points, and each convergence point aggregates four to six channels of high-definition video images, and then transmits them through points. , Transmitted to the monitoring center. The details are shown below: Factory wireless monitoring
彩票注册 七乐彩 必赢真人娱乐 欢乐拼三张